Single-story ranch house with a new charcoal standing-seam metal roof and dry hills behind it

Standing-seam metal roofs in Boise

Steel panels run in one piece from the eave to the ridge, fastened with hidden clips so nothing pierces the face of the roof.

Raised edge of a charcoal steel panel next to a hidden clip screwed to the deck over gray underlayment
The clip sits under the seam: the next panel locks over it, and no screw goes through the steel you see.

When steel is the right call

Standing seam costs more per square than shingles, and it is a roof you put on once. Owners who choose it usually tell us one of these four things.

  • Snow sits on the roofSteel sheds it faster, with guards where people walk below.
  • You plan to stayYou would rather pay once for the roof than plan a second tear-off.
  • No screws in the faceClips under the seams, so there are no washers to dry out and leak.
  • A cooler attic in JulyLight and reflective finishes keep the deck cooler under summer sun.
Cross-section of a pitched roof from the eave to the ridge, with each layer namedRoof deckIce and water barrierSynthetic underlaymentShingles or metal panelsFlashing and pipe bootsRidge ventDrip edgeGutter and fascia

What goes under the steel

The panel is the last layer of six. The lit layers are the ones this job installs; hover or tap a line to find it.

  • Roof deckChecked flat and solid after the tear-off: a panel shows every dip in the deck under it.
  • Ice and water barrierSelf-adhered membrane at the eaves and valleys, where melting snow backs up under the steel.
  • Synthetic underlaymentHigh-temperature underlayment rated for the heat that builds under dark steel in July.
  • Shingles or metal panelsPanels with 1.5-inch seams, held by clips that let the steel move as it heats and cools.
  • Flashing and pipe bootsPipe boots made for metal, and trim bent on site from the same coil and color as the panels.
  • Ridge ventA vented ridge closure under the ridge cap so the attic keeps breathing.

How a metal roof runs

  • Measure every slopeEach panel is ordered to the length of its slope, eave to ridge.
  • Color and gaugeYou pick the finish from samples on your own roof, in your own light.
  • Tear-off and underlaymentDeck checked flat, then barrier and high-temperature underlayment.
  • Panels and seamsClips screwed to the deck, panels locked over them one by one.
  • Trim and walk-throughRidge, rake and eave trim bent on site, guards over doors.

What a metal roof costs

Standing seam is priced by the square like shingles, with the tear-off included. Snow guards are priced by the foot and placed only where snow would fall on a door, a walkway or a lower roof.

Soft deck sheets are replaced at $85 a sheet before any panel goes on. The installation carries our 10-year workmanship warranty (demo value); the paint finish carries the panel maker's warranty, in writing.

Prices for Metal roofing, demo values
What you pay forPrice
24-gauge standing-seam steel, tear-off included, per square (100 square feet) installed$1,150 per square
High-temperature underlaymentIncluded
Snow guards over doors and walkways$18 per foot
Matching steel flashing and trimIncluded
Gutter removal and rehang during the job$4 per foot

Book a roof inspection

Call or send the form, and we set a time to look at the roof with you.

  • You call or writeTell us the address, the roof and what you have noticed.
  • We inspect the roofOn the roof, in the attic, at the gutters, with photos of what we find.
  • You get a written quoteItemized by layer and material, so you can compare it line by line.